Rear seal pouring !
1 - 4 of 4 Posts
Read this..Should solve your problems..
http://www.460ford.com/forum/showthread.php?t=135753&referrerid=25042
http://www.460ford.com/forum/showthread.php?t=135753&referrerid=25042
Joined
·
4,607 Posts
Sounds like the lip is facing the wrong way.
very good read will check when i get it out. Thanks !
1 - 4 of 4 Posts
Join the discussion
Recommended Reading
-
New CJ intake at PRI
Engine TechNew prototype at the pri show. Look's similar to blake's modified victor intake a few years ago!! https://www.facebook.com/photo.php?fbid=10157432403986953&set=pcb.2232513893517392&type=3&ifg=1&__tn__=HH-R&eid=ARAUyDnqHiG8OhiRChcpf2y2R9MA3kYRRB85NEk-U8J9YkxjcVIhQEatKRzBoyKnxuCLG5krxmvGRlTD...- 0
- 35
-
bob460 · updated
-
What head gasket..
Engine TechBlew anothet head gasket took .006 cut to clean heads. Have been running felpro 1018. Thinking of changing to felpro 1028 which has steam holes...any thoughts? .30 over with scj heads ,probe pistons scat forged rotating assembly, lem's grind comp solid cam,- 3
- 89
-
rdwest · updated
-
Fingers crossed Start Up this weekend
Engine TechHopefully all will go well : This is a list of what all I have done over the last couple weeks New Straight up Double Roller Timing Set...- 6
- 141
-
Storeman · updated
-
91 efi 460
Engine TechI'm building my 91 efi 460 a d with how I'm building it, I expect it to make at least 500 ftlb at the crank with around 380 hp. I have a c6 tranny in it and I looked it up, the stock c6 transmission is rated to 475 and considering it has 320k miles on it, I'm a little worried it would destroy...- 2
- 71
-
Big red oven · updated
-
Cobra Jet Headed 521 Cam timing?
Engine TechAll, I have a 521 that was built a couple years ago and I currently have it torn apart to discover what the engine builder had actually done vs. what I asked for. Im currently looking for cam timing recommendations for this combo. It will be going in a 1970 Torino with a C-6 and 3.91 gears...- 4
- 191
Join now to ask and comment!