[pedal2themetal45]

HI, this was the way I used and I think it works great..

 

[pedal2themetal45]

Hi, you might also need longer rocker arm studs??

good luck take care be safe
tim

 

[pedal2themetal45]

HI as Paul says in the picture he posted of yours Looks like your push rod is way to short.. at 0 lift if you put a straight edge on top of the valve spring cap it should be a straight line from the roller center to the center of the stud roller Yours is diffidently not your stud roller is way low.. which would mean very short push rod..
In your picture if you put a straight edge on top of the valve spring cap it lines up above the top of where the stud roller is and it should line up with the center of the stud roller at 0 lift..
If you follow what is said in the video you should get it right.. draw a straight line between the center of the valve tip to the center of the stud roller . .. lay a straight edge flat across the valve spring cap and the two rollers should line up at 0 lift.

good luck take care be safe
tim

 

[pedal2themetal45]

HI,, I was just looking at your pictures and in your first post the second picture that shows what looks like good geometry when I enlarged the picture the push rod isn't even touching the rocker .. you need at least another 1/4 inch or more longer push rod..

good luck take care be safe
tim