460 Ford Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
5,483 Posts
Discussion Starter #3

·
Registered
Joined
·
3,730 Posts
just need a .200" thick lash cap and some small block chevy valve spings and your good to go- where i don't know
 

·
Registered
Joined
·
1,419 Posts
c.evans said:
The 5.060" length on that intake valve has me concerned. Maybe it's a typo.
Charlie,
If it's not a typo, then it's certainly some oddball parts. Going to be a little short otherwise. Buyer beware :!:
 

·
Registered
Joined
·
3,956 Posts
That was my point Steve. Buyer beware. 5.060" is the BB Ford exhaust valve length. If it really is a 5.060" long intake valve, then it won't fit any of the Ford heads, not even the 1973 and up cast iron stuff with the shorter valves.

The only head I know of, that uses a 2.250" x 5.060" long intake valve is the 455 Buick T/A Performance aftermarket heads and they would need to have the 11/32" guides instead of the factory diameter of 3/8".
 
1 - 7 of 7 Posts
Top