460 Ford Forum banner

Video of 466 A429 Heads Roller - Mustang

2949 Views 9 Replies 7 Participants Last post by  Phantasea466

I have two more videos but I'm having trouble with the zippy login so I haven't uploaded them yet.

Finally got the zippy site to work. 8)


Video in the drivers seat


Been some requests for engine specs: If you guys need more info please let me know.

t's a 466 with A429 aluminum CJ heads (Charlie and Scott worked on the heads) with 13:1 compression and a BIG roller cam via Lem Evans 272/280 @ .050 and .727/.727 lift
The bottom end consists of a stock crank turned down to 2.200" with BBC Eagle H-beam rods and BRC domed pistons pinned together with 4-bolt splayed Engine Systems main caps and screw in block plugs.
The Victor Dominator is matched to the heads with some port work in the flange area via Charlie Evans and the Dominator carb is a Jim Evans Racing piece, it runs kind of rich on idle but at WOT it's BAD A$$


1 - 4 of 10 Posts
Video is working now

Video is working, For Now :?


I have a few short revs on another video but it's over 10mb so zippy won't let me load it . I created an account where I can load up to 20mb videos but for some reason my login isn't working. I sent a message to the help section.

With the BRC pistons I've calculated about 13:1 compression :twisted:

If I get time I'll try to convert the mov files to wmv and see if it will shrink

John, I guess you can come pick it up on February 30th, I'll be at the shop then :wink:

Thanks guys!

Bigbub1968 said:
Hey Damon! Try Streetfire.net, is free too, and you can upload up to 150 mb! You engine sounds nasty!!
Thanks! I hope it runs as good as it sounds :twisted:

I opend an account with streetfire.net but when I click on "upload" it gives me an error and says to try again later. Maybe it's too crowded :?:

The same with zippyvideos. I had to upload those two videos anonymously because my account isn't logging in correctly :?:

1 - 4 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.