460 Ford Forum banner

1 - 10 of 10 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter #1
I need.....................

MOTOR MOUNTS
HEADERS
INTAKE
CAM
ANY OTHER SWAP PARTS NEEDED

This is my first big block swap into a 86 4cyl Mustang
Adice will be appreciated

So far I have..............................
D9 block bored.60
piston
crank
D3 stock heads
C6 with 3800 stall
holley carb
 

·
Registered
Joined
·
360 Posts
there is a guy on Ebay selling swap mounts for $50 shipped for the pair. Me and a couple other members are using them i know. I have also been looking around on the mustang sites and a lot of people seem to be using them so....
 

·
Registered
Joined
·
289 Posts
stock parts or aftermarket?

I need.....................

MOTOR MOUNTS
HEADERS
INTAKE
CAM
ANY OTHER SWAP PARTS NEEDED

This is my first big block swap into a 86 4cyl Mustang
Adice will be appreciated

So far I have..............................
D9 block bored.60
piston
crank
D3 stock heads
C6 with 3800 stall
holley carb

I have a complete 460 I just pulled from my truck that I could take parts off of. Are you interested in stock stuff, like the intake, cam and lifters? I would think you'd buy new stuff there, but I have it if you want it. I also have some of the bracketry, but I'm swapping some onto my new engine, so let me know what you'd want.
 

·
Registered
Joined
·
7 Posts
Discussion Starter #7
Got a trans cross member and not sure if I need any brackets. I have that and the intake I might get from a buddy here in NC. I'll let ya'll know asap though. Thanks
 

·
Registered
Joined
·
360 Posts
I have a stock camshaft, timing gears/chain, pushrods, rockers, exhaust manifolds, intake manifold, etc... anything stock from a 460 except the rotating assembly...
 

·
Registered
Joined
·
22 Posts
I need.....................

MOTOR MOUNTS
HEADERS
INTAKE
CAM
ANY OTHER SWAP PARTS NEEDED

This is my first big block swap into a 86 4cyl Mustang
Adice will be appreciated

So far I have..............................
D9 block bored.60
piston
crank
D3 stock heads
C6 with 3800 stall
holley carb
I have a set of Truck Rods with upgraded ARP Bolts, 8 Pistons with rings, 2x4 Weind Tunnel Ram, a pair of Dove-a Ported heads with Valves, no springs. Pistons and Rings are .060 over also have a Clay Smith c306 8B Cam and solid lifters

512-751-6810
 
1 - 10 of 10 Posts
Top