460 Ford Forum banner
1 - 3 of 3 Posts

· Registered
Joined
·
127 Posts
Discussion Starter · #1 ·
I Have... 521.. P-51, New TFS Street Mafia Intake, 13.6CR, 272/284 780 Lift.
In a... 66 Fairlane..

What carb spacer do you think i need? Base plate of manifold with out carb on is one inch below the bottom of hood... I planned on a Prosystems carb..

I know i should strap it to a dyno and find out, but no one has one within 200 miles of me..

Thanks..
 

· Registered
Joined
·
5,320 Posts
Trial and error if you're going to figure it out using a dyno too! :) Spacers are something you just have to try to see if they help, hurt or make no change. Most of the time I test an engine without a spacer, then go to a 4 hole, an open and a merge. Keep in mind too that the most expensive spacer is often not the most effective on the engine.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top