460 Ford Forum banner

Will these swap out:? 460 4 speed to 5 speed

2035 Views 2 Replies 3 Participants Last post by  HEWITT88FORD
I have a 460 and 4 speed manual in an 87 F250.I have found an 89 F350 4x4 with a 460 and a 5 speed and transfer case.Will the 5 speed and its xfer case and its hardware bolt right in the place of the 4 speed and its xfer case.Both are hydraulic clutch.Wont I need the flywheel and starter from the 350?I can buy the whole truck if needed.Which xfer case and tranny will be in the F350.They look big.They are stock for the 89 F350.Thanks for the info.
1 - 3 of 3 Posts
should be the zf5 tranny. if it bolts on that 460 it will bolt on yours, i would just leave the t case on the trannywhen you do it, cross member mounts might be in slightly different places and depending on the length of everything your driveshafts may be a little to short or long. just a couple things to look at
TO GO FROM 4 SPEED TO 5 SPEED YOU WILL NEED NEW CLUTCH & PRESURE PLATE DIFERENT CROSS MEMBER DIFFERENT SLAVE CYLINDER CHANGE THE LENGTH OF DRIVE SHAFT .I DID THIS SAME SWAP IN MINE LAST YEAR
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top