460 Ford Forum banner

1 - 10 of 10 Posts

·
Registered
Joined
·
222 Posts
Discussion Starter #1
I'm looking to buy a driveshaft for a Fox body Mustang. 8.8 rear with 460/C6 setup. Engine is in stock location. I was going to have one built but looking for a deal and save some money if someone has one they don't need anymore. Let me know what you have.
Doug
 

·
Registered
Joined
·
6,697 Posts

·
Registered
Joined
·
222 Posts
Discussion Starter #6
Dave,
I can't help it, it's in my nature. Will you measure the driveshaft I sold you, that's the dimensions I need. Engine won't be in the car until Monday. I knew I should have kept the whole setup, that was a brand new shaft!
 

·
Registered
Joined
·
222 Posts
Discussion Starter #8
Dave,
I'll give you a call.

Phantasea466, magmanmick,
I would assume that if your engine was in the stock location (factory k-member), running a C6 (truck trans with long tailshaft) and have an 8.8 with the stock yoke it would be what I need. The car is nothing fancy just a bunch of spare parts I have around. I would ratehr run a C$ but using what I have. If either of you ran this same combo let me know and a price for the shaft shipped to zipcode 13044.
Thanks, Doug
 
1 - 10 of 10 Posts
Top