460 Ford Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
372 Posts
Discussion Starter #1
Just as the title says i am looking for a aluminum block. Prefer a wet sump set up. Let me know if you have anything Thanks,Tony
 

·
Registered
Joined
·
3 Posts
alum BBF block

I have an SVO Alum block, standard deck height, roller cam bearing
I believe is was cast by Alan Root. It has been in my shop for a couple of years but it is NEW has had no machine work done on it...I can go either dry or wet sump I also have other parts for this set up heads....crank ...oil pump...belt drive.....rods.....
PM me or call

"racecrafter"
Robert Abbate
512-439-9783
Austin Tx
 

·
Registered
Joined
·
4,607 Posts
I have an SVO Alum block, standard deck height, roller cam bearing
I believe is was cast by Alan Root. It has been in my shop for a couple of years but it is NEW has had no machine work done on it...I can go either dry or wet sump I also have other parts for this set up heads....crank ...oil pump...belt drive.....rods.....
PM me or call

"racecrafter"
Robert Abbate
512-439-9783
Austin Tx
How much for the belt drive? What make?
 

·
Registered
Joined
·
40 Posts
I have an SVO Alum block, standard deck height, roller cam bearing
I believe is was cast by Alan Root. It has been in my shop for a couple of years but it is NEW has had no machine work done on it...I can go either dry or wet sump I also have other parts for this set up heads....crank ...oil pump...belt drive.....rods.....
PM me or call

"racecrafter"
Robert Abbate
512-439-9783
Austin Tx


Do you still have the block? Picture?
Feel free to email me directly: [email protected].
 
1 - 8 of 8 Posts
Top