460 Ford Forum banner

1 - 11 of 11 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
HI , I am after copmlete blown BBF or parts to build, aluminum or cast. What do you have and price .
Please PM Lyle
Thanks
 

·
Registered
Joined
·
3 Posts
Discussion Starter #5
I am after an alcohol setup I already have blower and injection just looking for a long or short setup or parts to build . Aluminum block or A460 block or eliminator in cast.
Thanks Lyle.
 

·
Registered
Joined
·
352 Posts
res0rli9 said:
IS that a 61 starliner? I had a 401 back in 62' only had it 5yrs. befor some one stole it :evil:
res0rli9,
yes it's a 61 starliner. Wish i had stolen this one, it would have been a lot cheaper :lol:

George.
 

·
Registered
Joined
·
3 Posts
Discussion Starter #8
I will be running an 8/71 Hi Helix with carbon hat. I am looking for parts or engine to make around the 1800 hp plus. Aluminum rods, billet crank, blower pistons, cam, heads ,blower manifold etc. Thanks Lyle.
 

·
Registered
Joined
·
1,181 Posts
I'm building a blown alcohol 572, with a 14-71. You should call Carrol Carter at C&C Motorsports, he has a ton of experience building blown alcohol big block Fords. His website is http://www.candcmotorsports.com/. I would recommend an Eliminator Ultra block which is what I went with. Here's what I went with on my build, 6.8 inch Brooks aluminum rods, 4.5 Velasco billet crank with big block chevy snout, Milodon single idler gear drive, Arias blower pistons. Carrol can set you up with everything you need and he will make sure you have the right parts without any guesswork. Chris
 

·
Registered
Joined
·
40 Posts

·
Registered
Joined
·
1,450 Posts
roar said:
I am after an alcohol setup I already have blower and injection just looking for a long or short setup or parts to build . Aluminum block or A460 block or eliminator in cast.
Thanks Lyle.
shipping from the US is gonna be murder. I'll sell my A heads and short block but it wont be cheap! :D

I have alot in it.

A heads have jesel shaft rockers 1.81's
SS valves Springs set up for over #900 off the seat.
Very agressive cam ( I have the numbers )
A SVO block, O ringed. Danny bee belt drive
Dry sump , Front bearing support, Diamond flat tops 11.5:1
BME aluminum rods and a Scat forged crank with a shortned nose done by Adney Brown.
heads flow 465 @ .800
Isky red zone Extreme bushing lifters ( no needle bearings )
Pm me if your interested. It hasnt been for sale BUT ....... today only special ......
 
1 - 11 of 11 Posts
Top