460 Ford Forum banner

1 - 9 of 9 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter #1
Looking for a good DOVE block to build a stroker and install my CJ 4 bolt main caps on. Got something? 217-429-5858
 

·
Registered
Joined
·
724 Posts
DOVE block/4 bolt caps

Paul Kane on the forum had a nice one, DOVE block with the raised "A" (boss bulkhead) . Your 4 bolt caps would go right on. You might think about going the splayed caps though, its even stronger on a dove block than the SCJ/CJ bolts that went straight down. Either way your much better than a plain 2 bolt... Paul's # is 310-435-1900 or you can pm him on this forum. Good luck!!
 

·
Registered
Joined
·
109 Posts
Dove-A Block

I have a DOVE_A block that i have installed a billet splayed 4 bolt main caps and aligned bored. It is also been sonic tested and will take a .080 easily. This block is at .030 now. I can send pic if interested. It is still at the shop that did my machine work. I am asking 750.00 or best offer. I just cant afford to finish my plans of making a 557 race engine. I have work sheets. Thanks 616-4376365 Grand Rapid,Mi.
 
1 - 9 of 9 Posts
Top