460 Ford Forum banner

1 - 16 of 16 Posts

·
Registered
Joined
·
83 Posts
Discussion Starter #1 (Edited)
1999 Mustang GT
460 BBF, freshly rebuilt
c6 trans
2500-3000 stall converter
holley 750 dp carb
d3 heads with super cobra jet port job
weiand stealth super cobra jet intake manifold
hooker ceramic coated long tube headers
crane cam
7qt moroso oil pan
tubular a-arms with 300lb coil-overs
hurst roll control
mallory hyfire 6 ignition box
8pt cage, painted black
MM (or upr..not sure) full length subframe connectors
3.73 gears
fresh spider gears so it should last awhile
upr manual brake kit
flaming river quick ratio manual steering rack
all lights and power accessories still work
driveshaft has just been shorted, resleeved, and has new yoke
battery is relocated to the trunk
comes with a NOS plate kit and bottle, installed but not hooked up and never ran on this engine
body has 150k, engine has about 10 miles driving time, and was broken in properly before being driven
title is rebuilt, but the car is straight
built by Rob at Gearheadz Automotive

few issues that need addressed:
trans fluid leak...either a bad gasket on the pan or the dipstick is leaking
small oil leak where the manifold seals to the block, needs pulled and re-sealed.....nothing bad

parts that it needs to be ready to roll:
radiator
alternator
pullies
thermostat housing
fans
throttle cable (installed, but snapped)

$5000

car has above accessories in pics below, and theres several videos of it running and driving....the parts were borrowed and i have them pulled and will be returning them


i have a huge bag full of receipts, i tried to keep most of them











 

·
Registered
Joined
·
144 Posts
I suspected you were a good dude when i seen the car. . .

I KNEW you were a good dude when you made mention of driving a BBF powered 99 mustang to church on open headers. . . .Jesus has certainly granted you extra credit. . . well played.

good luck selling a tough car too. .
 

·
Registered
Joined
·
83 Posts
Discussion Starter #3
haha i really was at church..






also guys, im not desperate to move the car, but ide like to see it gone by april 16th, so shoot me an offer in PMs...the worst i could say is no
 

·
Registered
Joined
·
172 Posts
Nice, open headers are fun. Also, nice radiator caps. Why 2 if its not too nosey? Sure is a beautiful car tho. Wish i hads 8000, but oh well. Gotta concentrate on my mustang, or itll get mad at me.
 

·
Registered
Joined
·
25 Posts
Nice, open headers are fun. Also, nice radiator caps. Why 2 if its not too nosey? Sure is a beautiful car tho. Wish i hads 8000, but oh well. Gotta concentrate on my mustang, or itll get mad at me.
It looks like the upper hose sits a little higher then the rad cap so maybe there is 2 to help burp the cooling system....Anyways Nice car..Good luck with the sale
 

·
Registered
Joined
·
83 Posts
Discussion Starter #6 (Edited)
ok...things came up today and i really would like it gone...so instead of dicking around haggling and all that, im just going to post my absolute bottom dollar that im willing to take...im not desperate enough to sell it for any less, so dont bother asking...

5k without robs parts
6200 how it sits in the pics

absolutely no trades
 

·
Registered
Joined
·
1,941 Posts
Nice, open headers are fun. Also, nice radiator caps. Why 2 if its not too nosey? Sure is a beautiful car tho. Wish i hads 8000, but oh well. Gotta concentrate on my mustang, or itll get mad at me.
cause i was going to weld the one on the radiator off, but i just capped the over flow end. let the over flow come off the upper hose where the air can get out easier..


to bad you couldnt keep this.

im sad i didnt have the money to buy it after all the hard work i put into the car
 
1 - 16 of 16 Posts
Top